Description
Flag disc grinding ratio testing machine is a special equipment for flag disc grinding ratio test developed by our company, which can realize flag disc grinding ratio test. After years of market verification and continuous improvement, the device has higher precision and is more convenient to operate. The equipment can do 90% simulation of real grinding.
Flag disc grinding ratio testing machine can control the grinding angle, strength and speed evenly, and it also supports the setting of basic data such as time, speed and force. The device has the advantage of being compact and easy to use. In order to ensure safe use, the machine is also equipped with a protective cover, dust-proof, iron scrap recovery device.
Attention:
1. Please be careful not to fall, bump or vibrate strongly when handling the product. The inclination is less than or equal to 45 degrees.
2. The machine should be installed on the indoor fixed foundation, pay attention to easy operation and good ventilation. There should be no conductive dust and gases nearby that could corrode metals or destroy insulation. The heat dissipation holes of the fuselage should be kept unobstructed, and iron filings and dust should be cleaned immediately after use.
3. The machine adopts single-phase AC 220V power supply, the voltage range is 220v±10%, the maximum current is 20A, and the frequency is 50Hz. The load capacity of the power supply should be considered when wiring.
4. A knife switch or an air switch or a leakage protector should be installed between the machine and the power supply to completely isolate the machine from the power supply. The grounding wire should be installed on the grounding feet of the vehicle body and should be reliably connected to the ground.
5. Without the permission of the manufacturer, users are not allowed to disassemble the controller or motor by themselves to avoid electric shock or damage to the equipment.
6. Be sure to cover the protective cover before use.
