Description:
Our Rpm Test Machine for Flap Disc adopts KWHG-1 microcomputer rotary controller, which can realize reliable numerical control operation and automatically operate data. Secondly, the fuselage adopts the box structure, which strengthens the shock absorption function. The rotating box door is equipped with mechanical and electronic double locks, effectively avoiding accidents caused by accidental opening of the box door during operation. As for the main engine, this time we use a special high-speed motor with a rated power of 1kw and a rotating speed of 8,000 ~ 10,000 rpm, which has high operating efficiency and can quickly complete the task.
Features:
1. Our Rpm Test Machine for Flap Disc has a new digital thyristor trigger and relay no-load changeover function, which automatically executes the relevant procedures to indicate the fault situation when a fault is encountered, while an alarm is sounded.
2. All blocking switches of the machine are non-contact electronic switches, which can effectively protect against dust and oil, reducing the effort and cost of maintenance and repair.
3. It automatically generates acceleration and deceleration curves and records all operating data, regularly detects and deals with faults. Once you set the speed and time, press the start button and it will start to run fully automatically, effectively reducing labour costs and quickly increasing efficiency.
Special attention before use
1. The weight of the tester is 200 kg. Care should be taken not to throw, hit or shake it strongly when handling it, and the tilt should be ≤ 30 degrees.
2. The tester should be installed on a stable indoor plane, with attention to ventilation and no conductive dust or gases in the vicinity that could corrode the metal or damage the insulation.
3. the testing machine shall be powered by single-phase AC 220v, voltage range 220v±10%, maximum current 15A, frequency 50Hz. the wiring shall take into account the load capacity of the power supply.
4. An air switch or earth leakage protector should be installed between the body and the power supply to completely isolate the body from the power supply.
5. The earth wire of the body should be installed on the ground and reliably connected to the earth.
