Fully /semi-automatic flap disc forming machine shaping operation
1. Manual shaping
1.1 Shaping and pressing: Shaping the cylinder above the station. After the cylinder is compressed, the base body and the station are tightly combined and cannot slip;
1.2 Shaping cylinder: The cylinder next to the shaping station. After the shaping cylinder is close, the turntable in front of the cylinder can touch the semi-finished abrasive belt;
1.3 Shaping rotation: Shaping the motor below the station. Drive the station turntable to rotate;
2. Shaping
2.1 Confirm that it is not in the running state (the running indicator light is not on), and it does not act in the running state;
2.2 The shaping and pressing cylinder is pressed down, and the shaping station is rotated;
2.3 When the plate is pressed well (the sensor under the pressing cylinder is on); the shaping cylinder is close;
2.4 When the rotation angle reaches the set angle; the shaping cylinder is loosened and the shaping and pressing cylinder is raised;
2.5 When the shaping and pressing rises well (the sensor above the pressing cylinder lights up): End;
3. Automatic time shaping
3.1 Make sure that the station has been lined up when the film is set, otherwise the station will not be shaped;
3.2 Pressing down of the shaping and pressing cylinder, and rotation of the shaping station
3.3 After the plate is pressed tightly (the sensor under the pressing cylinder is on): the shaping cylinder is close;
3.4 When the rotation angle reaches the set angle: the plastic pneumatic loosening, the plastic pressing cylinder rises;
3.5 When the shaping and pressing rises well (the sensor on the pressing cylinder lights up): end
4. Other
Speed: The speed at which the station rotates. Range 90-150
Rotation Length: The length of the station rotation. Range 1200-2200
Products to take away after plastic surgery:
1) Reduce the exhaust speed above the compression cylinder (the restrictor valve is turned clockwise);
2) Reduce the pressure of the shaping cylinder;